The Stovebolt Site Forums The Shop Area Paint and Body Shop Mounting an outside sunvisor on a '57

RPO987182

SUN VISOR
INSTALLATION INSTRUCTIONS
All Trucks

--------------------------------------------------------------------------------



1. Position the visor to the under side of the roof panel windshield peak. Hold in position until one of the center support bracket holes is scribed. Remove visor and drill a 3/32 inch hole where scribed.

2. Apply windshield sealer to the entire length of the attaching flange of the sun visor.

3. Press the sun visor gasket on to the flange of the sun visor. Match the holes of the sun visor to the holes in the gasket to assure a better fit.

4. Apply windshield sealer to the outside surface of the gasket.




5. Hold the visor up to the under side of the roof panel windshield peak. With the visor centered in position fasten the visor to the under side of the peak at the drilled hole with one of the screws and lockwashers provided. As illustrated in No. 2.



6. Still holding the visor in position, and using it as a template drill and attach both ends next. Drill and attach the visor at the center and continue in the same process till completed.