I found a 12 volt alternator...I have heard these called 2 wire alternators but I think this is also referred to as a 1 wire.
http://good-times.webshots.com/photo/2808211950083206947leFsmC

I believe I can connect the red wire from the DA plug and the red wire on the fastener to the battery and the other DA wire to the ammeter. Then disconnect the voltage regulator and have a 12 volt system.

I also need 12 volt light bulbs and resistors in front of my fuel gauge and coil. This is a floor stomp starter.

My question is I have a 6v pertronics ignition. If I have a resistor in front of the coil can I keep the flamethrower coil and pertronics ignition set up for my current 6v system or do I need to replace them with 12 volt pertronics set up.

Thanks
Rich



1953 3/4-Ton Chevy

In the Stovebolt Gallery
More pix

If it can be built ... It can be fixed.

RB53