my truck came with one of those sig-stat 900's in it. i have gone through and rewired almost the whole dang thing (thanks to stupid people that think all wire is the same-extension cords, lamp plugs, jumper cables ect.) im down to the turn signals, and im going to use the sigstat for a while. am i correct to understand that the sigstat uses some part of the rear dual filaments as the turn signal? i have given it stand alone turn signals in the rear, so i was thinking i can run front and rear turn signals off just the front wires (red and green), but if i do that do i just not connect the grey/black to the break switch, and just cap off the black, and the grey leads since i wont be using them either? i made a diagram here
http://s94.photobucket.com/albums/l116/bctoste/?action=view¤t=SIGSTATWIRING.jpg. i think its right, but im not 100% sure. any help would be appreciated, thanks!
