ok had a crapppy v8 with a rod knock in my 60' stepside apache that came stock with a small six and three on the tree. now am swapping a 292 cu.in. with a m465 tranny and 69 chevelle rearend to begin with, later a 327 with m20 tranny. to make this happen I will use the original tranny bell housing to mount to the original cross member, then bolt/drill the new motor mounts in place (staggered), as they are side mounts not front mounted. should be easy enough to set the 292 in place is there any issues I may have to deal with when installing this drive train??