you will like the 5/8" chuck that's a plus. of course you could always get a s&d drill set even with a 1/2" chuck. it says it has a mt2 spindle, can you use any mt2 tooling? if so that's a plus too. i sold the last drill press i had several years back, just use my mill now. not quite as quick to throw on and off like a drill press but it's a lot better. like being able to adjust the drill position after your piece is locked down, that's nice, but not relative to everyone.
like sw radial said slow speeds are the best, especially for those holes over 1/2". so a slow speed is the most important thing i would look for looks like it goes down to 280. don't see a price but it may be there. did you check on any local used ones? the runout on these imports used to be a bear, but everyone says the quality is getting better.
