The Stovebolt Site Forums The Shop Area General Truck Talk Tail Light Conduit

I did mine basically the same way. I used a rubber grommet in the back of the tail light just about the same size of the smooth end of the conduit and pushed it into the gromet from the outside back end of the tail light. On the end that goes into the frame, I used a hard plastic grommet that has a hole in it so the conduit fits snugly through it but stops because of the flare on that end of of the conduit, then I pushed the grommet through a hole in the frame on the outside of the frame and it just snaps in. I found these grommets at the Ace Hardware Store near my place.