Loosen the hub bolts on the inside of the flywheel and remove from the shaft according to the I&T Service Manuel, but I have had to drive a small chisel into the gap on each side of the hub bolts then it should come off. The flywheel is really heavy so be careful. I have used a 6" c-clamp on the flywheel and chained to a cherry picker to hold it up whem removing it. Pick up a manuel at Tractor Supply because their is spicific instructions on installation
The john deere manual I have talks about loosening the rear pinch bolts- then using a puller to remove using the two threaded holes and the center guide hole- That's why I asked about the puller-
Is their another way?
Thanks,
Sam
