The Stovebolt Site Forums The Shop Area Engine Shop emergency brake cable for 10/12 bolt rear ends

I just talked with the NAPA 800 line and gave them the specs for the 'conduit length' and two types of ends I wanted.

The conduit length is the distance from the brake backing plate to the mount on the frame for the cable. The length on the original cables was about 30-32 inches.

The two ends I want are for a 12 bolt e-brake and the 5/16ths threaded end to use the stock clevis/yolks.

NAPA has a stock part which for 10 bolt/12 bolt rear ends with 5/16th fine thread end and a 28" conduit length. Part number 92416.

If NAPA is out of stock and cannot order it any brake shop can get it using that part number.

I'm going to order a set, bolt them up will post an update about whether they work or not.

FYI I'm planning on grinding down the conduit end on the threaded end to fit into the stock mount and if the conduit length is too short but the overall cable will work, I will grind out the bolt heads on the threaded end mount, place them where they need to be on the frame, drill some holes and bolt them in with grade 8 bolts.