I had to pull a wheel to get a cab off, and didn't have a puller, so I made one, then I get to taking the wheel off and it about falls off once I remove the nut, didn't even get to use my fancy puller frown

Made it from a 1/2 x 3/4 bar a couple inches long. Drilled two holes the right distance and size to bolt to the hub, and in the center between the two drilled a 1/2" hole and welded a 1/2" fine thread nut over it, add a bolt, wrench, and a hammer and it's a puller.

Grigg

•1951 GMC 250 in the Project Journals
•1948 Chevrolet 6400 - Detroit Diesel 4-53T - Roadranger 10 speed overdrive - 4 wheel disc brakes
•1952 Chevrolet 3800 pickup
---All pictures---
"First, get a clear notion of what you desire to accomplish, and then in all probability you will succeed in doing it..." -Henry Maudslay-