So my h20 pump is leaking out the weep holes. It is off a 54' Chevy 1/2 ton in line 261, the original engine was a 235, but I believe the same pump went back on, there is only 1/2 clearance before the fan. So anyway I took the pump to NAPA, nobody makes the pump although I can get one from ChevyDuty or someone for roughly $70 plus shipping, or I can take the h2o pump my guy at NAPA got which is exactly the same except the shaft is a little longer than I need, then I can take it to a machine shop around here, Megis Machine shop, they can cut the shaft to match the original and press the pulley base back on. Good Idea? Bad Idea?
ever in search of knowledge
rje
