I just recently got a clifford 2/4bbl aluminum intake manifold w/ a 4bbl adapter for my 52 235. I also purchased a holley 390cfm 4bbl carb to top it off and was wondering which is the best positioning for it on the intake. Im going with a cable type gas pedal and it would be the cleanest and shortest run if the carb could be positioned on the intake where the connection for the throttle cable was on the driver side toward the fender. This way the cable could run up along the firewall and just make a turn towards the front of the truck and directly to the carb to minimize bends and length of cable. This would also keep the fuel line routing simple.

The carb:
http://store.summitracing.com/partdetail.asp?autofilter=1&part=HLY%2D0%2D8007&N=700+115&autoview=sku

Basically looking at the picture on summits site, thats the position as if you were standing looking at it from the driver side front.

The gas pedel:
http://www.lokar.com/product-descriptions/eliminator-fm-throttlepedals.htm

For the cable im also using lokar

Would this be fine?

Last edited by drummin52; 04/27/2008 1:26 AM.