| |
Click on image for the lowdown. 
====
| | |
9 members (KEVINSKI, Phak1, Rusty Rod, GMCJammer51, Rusty Heaps, 68ironhead, carbking, Jeff Ogden, 1 invisible),
378
guests, and
4
robots. | | Key: Admin,
Global Mod,
Mod | | | Forums66 Topics128,162 Posts1,057,042 Members48,463 | | Most Online14,466
Apr 26th, 2026 | | AD Chevy Trucks  Over 6,000 pictures Brad Allen has an awesome collection of Chevrolet factory pictures that he has set up from film strips. Check them out!
Lots of work on Brad's part ... pure enjoyment (and references) for you!
| | THANKS!
For helping keep this great
old truck web site
on the Internet for over 30 years! and not clogged down
with Ads!  Again, thanks!
| | | | Joined: Jan 2006 Posts: 2 Junior Member | | Junior Member Joined: Jan 2006 Posts: 2 | I bought a 48' chevy 1/2 ton sight unseen, everything is great except the runningboard apron and fenders don't line up. I have been under the bed trying to figure it out. So maybe you guys can help. The builder used 3" steel square tubing as a mounting spacer in the front, the rear has the wood block with rubber spacer 2 1/2" tall. My problem is the runningboard apron shows about a 1" to 1.5" gap from the bottom of bed to of apron. The curve in the running board apron doesn't line up with the curve on the fender, looks bad. I think the bed is too high. Is it easier to lower the bed or shim the running boards to fit the fenders? Any suggestions? | | |
|
|
| |
