I have a new bracket and a dual master cylinder that I am trying to install on my 3/4 ton. Well I got the old master cylinder off, but I have yet to get the bracket off. In order to get to the last bolt holding it on the frame, I wanted to remove the pedal shaft that goes through the bracket. I have the pedal shaft taken apart and the end bolt is off, but I cannot get it to budge. which side is it supposed to come out of, or does it matter? I have removed the clip, end cap, spring, other cap and washer from the inside of the shaft and the bolt from the outside, now I cannot find anything else to remove. My manuals dont discuss this at all so I am looking to you guys that may have done this before to give me some much needed advice.
While I am at it, is there any other way to get the pedals out of the cab without removing the pedal shaft from the frame?
Thanks in advance.
Tom
