The parts I purchased were not what I would call a good fit for over $800. I replaced floors, braces, toeboard, inner and outer cowls, rear cab corners, fab'd rear floors and cab back at floor area between cab corners. The inner cab corners were short, I had to reorder elsewere, the inner cowl peices were no where near fitting the curve into the floor, had to cut off bottom add and reshape. Outer full cowls were good, floor left and right seemed ok but the transmission pan did not fit after assembly, about 3/4" wide, toe board was ok, inner to outer cowl panels had to be extensively reshaped. Yah will be good with metal when done, but it gets you close, better than nothing. If I were to do again I think I would try Bitchin Street rod flooring which does not include cowl parts or look for a rust free cab. Zeke
