| |
Click on image for the lowdown. 
====
| | |
0 members (),
258
guests, and
5
robots. | | Key: Admin,
Global Mod,
Mod | | | Forums66 Topics128,077 Posts1,056,013 Members48,433 | | Most Online14,466
Apr 26th, 2026 | | AD Chevy Trucks  Over 6,000 pictures Brad Allen has an awesome collection of Chevrolet factory pictures that he has set up from film strips. Check them out!
Lots of work on Brad's part ... pure enjoyment (and references) for you!
| | THANKS!
For helping keep this great
old truck web site
on the Internet for over 30 years! and not clogged down
with Ads!  Again, thanks!
| | | | Joined: Oct 2005 Posts: 1,317 Shop Shark | | Shop Shark Joined: Oct 2005 Posts: 1,317 | Don't know if this will do you any good but drilling the channel in a few spots and hitting it with a small rod and lower amperage should do the trick. That's assuming you've got access to a stick welder. If that isn't the case I'd be tempted to use a pop rivet and a heat gun to warm the rubber so you could work it around the head. Mine didn't go into the track and feed around....had to work it in with a blade, inch by brutal inch!!!
I've got an old-time stick welder....sprung for a mig w/gas.....great for occasional light work but I get a whole lot more use out of my stick or oxyacetylene. Kinda hard to justify having that kind of coin tied up in a machine unless you're using it on a regular basis.
Dave | | |
|
|
| |
