Thanks, Jon. You may recall the summer I was doing the "Rochester Project" and the numerous conversations we had. Hundreds of digital images showing I tried and tried to come up with ways to make the power piston seal better (the bores are always worn and so are the pistons) and most especially to keep the pistons from sticking in the bores (which disables the power system completely and makes the carburetor run extra rich). I tried o-rings of all types...viton, hdpe, ldpe, nylon, rubber, teflon...most of which I still have here. Every one of them failed. I tried pure silicone grease between the o-rings...which is supposed to be resistant to gasoline. And finally I came up with a scheme to use a formed aluminum piece and an o-ring to prevent gas from being sucked up in there. My final attempt before admitting it can not be done or at least it can't be done by "everyman."

You can see much of it below in various images along with an image of one of the Chinese Rochester B "copies" showing 3 (count them, 3) vacuum inlet locations for the automatic choke. A really interesting approach, I thought. Sometimes if one vacuum pipe works well, three might work better.

As for the power piston, this is truly one of the Achille's Heel problems of the carburetor and nothing I tried helped because vacuum still sucks gasoline up in the area and it still always turns to a sticky mess. I even tested gasoline and various gas additives. I could not see any way to keep the gum from disabling the thing and it all goes back to basic design combined with no more real gasoline. I tried to keep an open mind and honestly because I've been around these carburetors for over 60 years (ugh) I tried to be as optimistic as possible but I decided there is simply no comparison between these and the Carter YF...and because of cost I didn't even get into Zenith and other options.

However if the airhorn had been attached using more than 4 screws and if the power piston scheme had been located outside of the carburetor the carburetor might have worked much better. Images below...
Attachments
Chinese Rochester1.jpg (67.49 KB, 16 downloads)
Rochester install 1.JPG (30.14 KB, 15 downloads)
Rochester seal idea.JPG (38.89 KB, 15 downloads)
MVC-770F.JPG (17.26 KB, 16 downloads)
MVC-723F.JPG (36.86 KB, 15 downloads)
MVC-722F.JPG (25.18 KB, 17 downloads)
MVC-721F.JPG (18.06 KB, 16 downloads)
MVC-720F.JPG (17.98 KB, 17 downloads)
Rochester HDPE.JPG (43.88 KB, 16 downloads)


~ Jon
1952 1/2 ton with 1959 235 | T5 with 3.07 rear end