I installed my pinion in the standing position. You said the retaining ring was even in all three holes, but is it located properly? I mean, one side of the retaining ring has a taper/bevel. Do you have it in the correct direction where it sits against the three retaining bolts? Just a thought.
Attachments
IMG_8801a.jpg (131.96 KB, 102 downloads)
IMG_8804a.jpg (103 KB, 95 downloads)
IMG_8746a.jpg (90.02 KB, 95 downloads)

Last edited by UtahYork; 11/16/2025 6:16 PM.
~ John in Utah
1946 1/2Ton w/4-speed manual transmission w/1960 235 engine
Here We Go
Follow in his DITY Bay

- If you think about it, it has been one year ago today!