More pictures The holes for the knobs I put a 1/2 inch drill bit in and it fit loose but I don’t know if the next size would go through as I could not find one . They is a picture of the end of the plate and i roughly cut out some paper to show you the contour of the dash as it curves up .i will read over the measurements you would like me to check and get back to you .Kevin
Attachments
IMG_6065.jpeg (218.76 KB, 124 downloads)
IMG_6064.jpeg (147.1 KB, 124 downloads)
IMG_6063.jpeg (130.73 KB, 124 downloads)
IMG_6062.jpeg (237.16 KB, 124 downloads)
IMG_6059.jpeg (193.88 KB, 124 downloads)
IMG_6058.jpeg (280.78 KB, 124 downloads)
IMG_6070.jpeg (395.4 KB, 124 downloads)
IMG_6067.jpeg (284.84 KB, 125 downloads)
IMG_6061.jpeg (220.15 KB, 123 downloads)
IMG_6073.jpeg (393.28 KB, 123 downloads)

1954 Canadian GMC 9300
"The Journey"
Follow in the DITY