I did not put this in myself. My good neighbor again. I would not recommend someone try alone. I set it in with the rope and without. On these, I worked with 58/59 the rubber will roll over the inside. You can set the bottom in first and go from there. Its a left right left right getting the glass to work its way to set. Lotsa glass cleaner /soap. Rubber is your worst enemy here. If it catches and rolls back on itself ,it will not move. A pointy glass tool is important. I got the most done with someone slapping the outside where I had the rubber inner lip peeled out and down. This pulled down and in the ledges on the rubber seals are now at an angle and it just slides in after some slaps. Always fold up a towel and use to slap on. When the rubber rolls in and locks ,you know it.
Last edited by Guitplayer; 08/04/20241:24 AM.
~ BD. "You won't find me in an old folks home" Pioneer Florida Cracker 1958 Apache Stepside 1958 Apache 1/2 ton Panel 1959 Apache 1/2 ton Panel
