I just saw this thread.
I just purchased a well reviewed plasma cutter. I have only experimented. I have spent less than one minute testing how well it cuts and I think I have a lot to learn.
I’m not ready to give it a good review or a bad review. I am pleased with the package contents, and how easy it was to set up. I did see one very positive YouTube review by an independent shop. Here is my video about the machine, and I will post another video once I figure out how to properly use it. I need to play around with the air pressure settings and voltage settings.
MY VIDEO OPENING THE BOX

Someone else’s video review.

Last edited by Lugnutz; 04/10/2024 3:43 PM.
1965 Chevy C10 Shortbed 1/2-Ton Stepside
Truck College
In the Stovebolt Gallery
In the Project Journals Forum
The Build BLOG on Weebly
T5 Transmission Build page