I was able to remove the fork after backing out the trans about 2 inches. My bell housing had a set screw that could be backed out as the pivot ball. The trans was in front of that. Or back as the case being. Yours may not. Putting the new one on was tricky. It'll pop on the pivot ball. I think the fork is designed to be removed ,either thru the bottom or side. Here`s a pic of my bell housing before I put the right clutch fork in.
~ BD. "You won't find me in an old folks home" Pioneer Florida Cracker 1958 Apache Stepside 1958 Apache 1/2 ton Panel 1959 Apache 1/2 ton Panel
