Although this doesn't answer your question on if lock washers are required or not, I did come across this possibly helpful info about the torque specs for the manifolds.

According to this list (see Note 1 below chart) the torque values are indicated as:

Quote
End clamps 20ft.-lbs., center bolts 30ft.lbs.

Also found this previous Stovebolt conversation on 250 torque specs. There is an old but still active link in there to GM I6 engine torque specs for 1966 that should also apply to your '67 250. See the screenshot below for details.

I don't have a Chevy shop manual covering the '67 250 engines, so can't confirm if these are accurate or not???

Anyone else have that resource to confirm???

Dan
Attachments
Torque Specs for 1966 GM I6 engines.png (309.69 KB, 84 downloads)
GM I6 Engine Torque Specs

~ Dan
1951 Chevy 3 window 3100
Follow this story in the DITY Gallery
"My Grandpa Carl's Truck and How it Became Mine"
1966 Chevelle (Wife's Hot Rod) | 2013 Chevy Silverado (Current daily driver)
US Army MSG Retired (1977-1998) | Com Fac Maint Lead Tech Retired (1998-2021)