I know alot of you run the Howard M4F Cam, so I hope this is not a dumb question.....But, the card reads .014 for intake & .016 for exhaust, fine, then it says to set the valves .005 tighter than recommended for running, to compensate for loosening during break in. I'm sure this is tried & true, but in my head it seems tight, has everyone set their valves with this cam to the letter as stated in the directions? And not had any problems? O.K really dumb question #2, if I set the valves .005 tighter, I will have the intake at .009 & the exhaust at .011 correct? Thanks in advance.
