The Fulton installation instructions tell you to drill four .110 holes (no. 35 drill). I’m not familiar with a “no. 35” drill bit. Is that what size I’d ask for at the store or is there a corresponding size like 1/8” I should ask for?

Also, regarding my original post asking what size screws to use, I finally found in the instructions where they say to use eight 6 x 3/8” self-tapping screws. I’ll have to buy some. Are self-tapping screws that much different than regular sheet metal screws except for the “drilling” tip on a self-tapping screw?

What say you Bartamos???

Thanks

Chuck
1950 Chevy 1/2 ton (all original)
1951 Chevy 1/2 ton (future streetrod)
1941 Chevy coupe
1938 Chevy coupe streetrod