The truck has sat for several years and with it rust has caused some grounding issues with the tail lights. To my understanding the bulb, in this case a LED lens assembly, grounds through the housing, through the bolts to the bracket and then from the bracket to the truck bed. Correct? If so, I will attack these areas by cleaning them up and seeing what works. I know its a ground issue since I can ground the assembly to the rear bumper and it turns right on.
Second, I would like to make and install a metal conduit loom for the tail light pig tails. I have seen the tech tip that addresses the SS loom sold by the vendors. Has anyone made there own? If not, I don't see how that SS loom attaches to the back of the tail light assembly.
As always, any and all advice is appreciated!
