Carl ,

The two cylinder guide pins get screwed into the cylinder block

Front & Rear holes on the manifold side of the engine .

This holds the gasket in position so you can guide the cylinder head into place .

You can do a trial fit when the block & head are super clean .

Screw the guides thru the head gasket .

You could go to the hardware store & buy a couple of carriage bolts - 1/2 " - 13 x 5 or 6 inches

and cut the heads off to use as guides .


PIC

https://i.postimg.cc/FsPJfZVH/261-head.jpg


George
'54 3600

1954 3600
A big help to many on the Bolt
Now cruising in
The Passing Lane