No offense taken, Yar. I’m still learning on most of this stuff and hope I don’t regret the decision I’ve made. I was looking at the tig for a lot of thin steel sheet metal work that I plan to be doing in the future. I’ve only welded aluminum once in my life so far. I doubt I will be doing much of it in the future. I’d hoped that this machine would be adequate and I think it will. My pal mentioned the same thing you said about “too bad it can’t tig aluminum” but I think I will be ok with MIG spool for aluminum. I’ve gotten pretty consistent with a MIG. (Not that it’s too hard... 😉)
By the way, those are some nice beads.
Last edited by Fox; 02/21/2019 5:14 AM.
