First drill a hole throught the center of the bracket that wraps around the Steering Column

Then mount the turn Signal Switch to the Steering Column

I used a center punch and then Drill a small pilot hole through the center of the wrap through the Steering Column

Use a sheet metal screw that taps it's own threads and screw it through the pilot hole and tighten it up

I chose to locate the Turning Signal Switch a bit up from level so I could see the light on the switch through the spokes of my steering wheel ..

thx to Carl52 for giving me the measurement I needed so not to use too long of a screw,, so not to interfere with the inside shaft that the sterring wheel is attached to

https://photos.app.goo.gl/BnAAqFyVncHlfqRh2

https://photos.app.goo.gl/KitBgkvml4mt2WJT2

Last edited by idaho39; 10/26/2017 3:32 PM.
Directions are just another man's Opinion