Hi,

I just replaced my brake light switch (on the side of the master cylinder under the drivers side floor) with a new unit with screws in the ends of the two posts that stick out from the switch.

My old unit has two posts but the end holes appear not to be threaded. Instead there are two holes going crosswise through the posts. Can anyone tell me what was the factory solution for attaching wires to the brake light switch?

See photo of switch:
https://goo.gl/photos/Ehg1d3XUyszUt7Ak7

Thanks!

Doug


1940 Chevy 1/2-Ton
In the Stovebolt Gallery
Lots more pix of my truck