Considering putting 18" wheels rear and 17" fronts on my '54 3100 1/2 ton. Could be 17's all around. The point is I want a wider wheel and tire than the stock 15's. I don't like fender flares FYI.
So for those of you who have done this appreciate your advice in advance.
Not much room (width) inside the rear fenders as it exists. I can see remounting the shocks inboard which is not a huge deal and looks like you can swap around the existing brackets to accommodate that effort..
It also looks like you can remove the inner fender well sheet metal. But then you have the bed right behind it. And that is the challenge.
How have you guys done that? Did you just simply tub it or?????
Ideally I would like to fit say a 235/60-18" in the rears.