| |
Click on image for the lowdown. 
====
| | |
2 members (JW51, TUTS 59),
133
guests, and
4
robots. | | Key: Admin,
Global Mod,
Mod | | | Forums66 Topics128,089 Posts1,056,362 Members48,442 | | Most Online14,466
Apr 26th, 2026 | | AD Chevy Trucks  Over 6,000 pictures Brad Allen has an awesome collection of Chevrolet factory pictures that he has set up from film strips. Check them out!
Lots of work on Brad's part ... pure enjoyment (and references) for you!
| | THANKS!
For helping keep this great
old truck web site
on the Internet for over 30 years! and not clogged down
with Ads!  Again, thanks!
| | | | Joined: Apr 2005 Posts: 2,832 'Bolter | | 'Bolter Joined: Apr 2005 Posts: 2,832 | Will try to get you some measurements tomorrow but if you have the filler panels that fit between the rear top of the running board and the bottom front of the bed that will place the running board to where the board to fender holes are aligned. The gap between board and cab is around 1 to 1.5". There is a rubber seal that goes in the gap. We have a 1950 Chevy "Unibody" mule that has the cab, front clip, and the bed welded to the back of the cab (with spacers) to give a one piece unit to lower down over a donor frame, be it S10 or other, and then after satisfied with the stance measurements are taken to build custom mounts.
Evan
| | |
|
|
| |
