You can do two tone three ways but I only recommend two of them. The first is a BC "base clear" you simply paint the first color about 4-6" past the area that you want your line. than tape your line spray the next coulour. pull your tape when the paint is still a little tacky so that the you dont have a really hard line than clear the hole truck.

The second is with single stage. you want to work from the bottom up. set your line for the lower colour spray it. will the paint is still a little tacky tape the lower line. use some fine line tape on the lower line put it right on the edge of the first paint colour. now spray the upper colour no as soon as your down spraying the second colour pull the fine line tape so that the upper paint will just slowly run and fill in that line. and fill in so you dont have a hard edge.

When the paint has cured enough to wet sand wet sand the line this should give you a nice line without any knowticable hump between the two paints.

The third way is basically like the first but you have to back mast and there is a lot of wet sanding to get the over spray off.

DUSTY G.

you can do anything you want as long as you have an O [censored] man in case you mess up