Tim/Pete, This has a single u-joint (model 101-22). The cross member that causes the interference is the one with the transmission mount (I've removed that so the only thing left is the cross member itself). I can remove the slip yoke but there is not enough room to remove the housing ball (I need just another 1/4" to get that off but the splined shaft would still prevent me from dropping the shaft to the floor. Maybe if I could wiggle the housing ball off I could get the torque tube up high enough to remove the transmission as suggested but with the housing ball on the torque tube, I don't think the transmission could move far enough to the rear to get it off. I'll look at it again tomorrow. Thanks for the quick replies.
