On my '53 3100 truck, the door remotes are as shown in the picture below:
http://lymanhall.smugmug.com/Trucks...i-TnVDCvR/0/M/Door%20Operator%201a-M.jpg This causes interference when the trim panels are installed.
The factory training film clearly shows the connecting rod running through the indent in the door:
http://lymanhall.smugmug.com/Trucks.../i-PBFJ5m2/0/M/Door%20Operator%201-M.png Which would seem to eliminate the interference problem.
I can't figure out how to install the controllers per the factory picture. I have tried flipping them upside down (doesn't work), and swapping left/right mechanisms (also doesn't work).
Any ideas?
