I'm deep into repairing my cab. ya I should have bought a better one but didn't. Anyway all I have left is roof pillars and top cowl panel hanging. I built a brace inside cab. I bought a replacement rear cab panel and I am confused as how to put it on. I used my air saw and cut right below the bulge line and I can see that the cab cross brace needs to come out. I cut all the spot wels inside cab along back but can't figure out how they did all the welding at ends. It looks like to get to it I'd have to take off rear panel on inside around windows? If not I was just going to cut up a couple inches at corner windows to get access to welds then just weld section back in. Has anyone every replaced this entire panel and can shed some light on it. Thanks you can also call me at 724-433-9015 Chris.