We are still asking: What did you get done on your Bolt today ????
The question, initially posted May 23, 2005, was:
"Whatcha do on your Bolt this weekend?"
After 51,906,997 views, 7378 replies over 185 pages, this thread in General Truck Talk is a happening! And it's not just weekends anymore.
My panel appears to have had just one seat. Jack under that. Without any support on the underside for a bench. Does anybody have a pic of how this originally would have looked like with a single seat? And can this support a bench or bucket seats.
Not sure what year yours is, but that raised seat support will be strong enough for a seat. Putting in a bench seat would make it harder to access the cargo area.
Mine is a 1958. 1/2 ton is it possible to get this floor pan setup for 2 seats? I have the front repair panels. Also ..is the rear support available? This cross member is shot. Pic from underneath and top.
I can't speak to your series, mine was an A-D, 1953. The back of the passenger seat would fold forward and then the whole seat would pivot ahead, putting the seat on the floor, almost under the dash. This was so you could get into the cargo area. Your driver's seat looks similar to what the A-D panels had.
