We are still asking: What did you get done on your Bolt today ????
The question, initially posted May 23, 2005, was:
"Whatcha do on your Bolt this weekend?"
After 51,906,997 views, 7378 replies over 185 pages, this thread in General Truck Talk is a happening! And it's not just weekends anymore.
Hello All, I am still looking for a 3/4 ton or one ton frame to start a project, however, I will buy a half ton frame instead, and switch the plans a bit if I find one. I need to try to start while I still have good weather, and I'm not getting any younger! If know of a half, 3/4, or one ton frame or complete rolling chassis that is available, please let me know. Thank you! Mike Stone.
When I ran a shop in Atwater I might have been able to help out, but that was in the mid-1970's. There was a used car lot there back then called "Econo-Cars". The owner's son build a car similar to the Crown Corvair with a mid-engine V8, but he did Crown one better- - - -instead of a small block Chevy, he used a 392 Chrysler hemi! Harry would be in his late 60's or early 70's now. If you can find him, it's possible he's still got a few connections in the central San Joaquin valley. Good luck! Jerry
"Freedom's just another word for nothing left to lose" Kris Kristofferson
Cringe and wail in fear, Eloi- - - - -we Morlocks are on the hunt!
Please allow me to clarify. I am seeking an advanced design pickup frame, 1947 to 1953. I need a 3/4 ton or one ton, not 1/2 or ton and a half. Either GMC or chevy. Not a COE or anything other than pickup. Thanks for any suggestions.