The Stovebolt.com Forums Home | FAQ | Gallery | Tech Tips | Events | Features | Search
Time to gathering together!
Fall Happenings
Since we put up promos last two weeks, we have had a bunch of activity in
The Side Lot.
See what's happening with a Stovebolt Collective near you
.

THE SIDE LOT
From Coast to Coast and some International gatherings listed, too.

Next up: too many to list!

THE SIDE LOT.

Go see!

Searching the Site

Get info about how to search the entire Stovebolt site here. To do a search for just the forums, get those details in the IT Shortbus fourm.
Old Truck Calendars
Months of truck photos!
Nothing like an old truck calendar

Stovebolt Calendars

Check for details!


Who's Online Now
15 members (Bill Hanlon, 50Chevy3100, 3B, 2ManyTrucks, 55shaker, 1 invisible), 93 guests, and 3 robots.
Key: Admin, Global Mod, Mod
Forum Statistics
Forums60
Topics129,173
Posts1,047,453
Members46,209
Most Online1,229
Jan 21st, 2020
Step-by-step instructions for pictures in the forums
Previous Thread
Next Thread
Print Thread
#1391579 Wed Jan 06 2021 11:56 PM
Joined: Dec 2020
Posts: 77
L
'Bolter
I removed my under bed fuel tank from my 47-48 3/4 ton. It is not like what is pictured available in the after market parts suppliers. It measures 7 1/4" deep x 12" wide and 41" long. It is supported from two brackets that are riveted to the frame and straps that go under it from the frame to the end of the bracket by the drive shaft side. The fill spout is located on the top near the rear and the gauge sending unit is also on the top just in front of the fill spout. The cross sills are way above and do not come anywhere close enough to the tank for any interference. Is there anyone that reproduces the proper tank for the 47-48 under bed tanks? I can repair my tank (dents) but I would consider a new one if it was available.

Attached Images
Last edited by lumbersawyer; Fri Jan 08 2021 12:16 AM.
lumbersawyer #1414238 Fri Jun 18 2021 10:24 PM
Joined: Jun 2019
Posts: 50
R
'Bolter
That tank is not available anywhere. I found a good used one for my 3/4 ton, had the outside sand blasted and I sealed it with POR15 tank sealer, and the inside as well. I'm keeping my eyes open for a spare just in case. If you decide not to use that tank, let me know.

lumbersawyer #1414304 Sat Jun 19 2021 06:47 PM
Joined: Apr 2016
Posts: 128
A
ASU Offline
'Bolter
Sawyer,

I second what RyanC said, the tanks are not reproduced. I put a generic one in my 48 3600, between the back of the cab and the next cross member. if you do some searching, and have some fab/welding skills, it isn't a huge obstacle.

Jon

Attached Images
IMG_0118.JPG (25.6 KB, 79 downloads)

Moderated by  Justhorsenround 

Link Copied to Clipboard
Home | FAQ | Gallery | Tech Tips | Events | Features | Search | Hoo-Ya Shop
Powered by UBB.threads™ PHP Forum Software 7.7.5