The Stovebolt Page Forums Home | FAQ | Forum | Swap Meet | Gallery | Tech Tips | Events | Features | Search | Hoo-Ya Shop
Helping out ...


EVENTS

Check in for status!

Jump over to the Events Forum, to post events -- new ones or the ones we have been enjoying for some time.
Look to see what's been cancelled or postponed.

Encourage one another!

Stovebolt Site Search
 
Old Truck Calendars
Months of truck photos!
Nothing like an old truck calendar

Stovebolt Calendars

Check for details!


Who's Online Now
16 members (Alainfrenchie54, 50wudy, 4100 Fire Truck, 1955 1 Series, 47 BOMBER, 1 invisible), 173 guests, and 4 robots.
Key: Admin, Global Mod, Mod
Forum Statistics
Forums50
Topics118,875
Posts951,520
Members43,285
Most Online1,229
Jan 21st, 2020
Image Posting Policy
Previous Thread
Next Thread
Print Thread
Page 2 of 2 1 2
Re: Computing Dwell From Point Setting
Eureka Jim #1341909 Mon Jan 13 2020 05:18 PM
Joined: Dec 2017
Posts: 709
D
Shop Shark
This is a sun tune up card for 59 235. You will note that the dwell is expressed as a range from like 28 degrees to 35 degrees. So you set your points and then check the dwell to see if it is in range. So that’s what you are looking to do. Not really a more precise specific number, but a range that you want to fall into after setting the point gap.

Attached Files
Last edited by Dragsix; Mon Jan 13 2020 05:19 PM.

Mike
Re: Computing Dwell From Point Setting
Eureka Jim #1341922 Mon Jan 13 2020 06:38 PM
Joined: Feb 2013
Posts: 221
E
Shop Shark
Thanks everyone for the information and discussion. Following Jerry's regular advice to "test not guess" I'm bringing as much information, as well as assorted test equipment, as I can to help figure out why a freshly rebuilt engine has developed running problems. I don't actually expect the dwell angle is the problem but I'll want to get all the basic stuff set properly before drawing a conclusion. If we can't find out what's happening with his engine I'll be starting a new thread---with more information--and asking for your help again! Jim

Re: Computing Dwell From Point Setting
Eureka Jim #1343669 Sun Jan 26 2020 01:18 AM
Joined: Dec 2019
Posts: 40
F
Wrench Fetcher
Don't forget changing the dwell setting will affect timing as well. You will need to retime. As a general rule on a 12 volt engine 30 degrees dwell should get you in the ball park. You will need to find a spec sheet for your engine for the correct dwell

Page 2 of 2 1 2

Moderated by  Rusty Rod 

Link Copied to Clipboard
Home | FAQ | Forum | Swap Meet | Gallery | Tech Tips | Events | Features | Search | Hoo-Ya Shop
Powered by UBB.threads™ PHP Forum Software 7.7.4