Check in for status!
Jump over to the
, to post events -- new ones or the ones we have been enjoying for some time. Events Forum
Look to see what's been cancelled or postponed.
Encourage one another!
1,229 Jan 21st, 2020
carrier measure location
Am I measuring in the wrong spot on the propeller shaft yoke? I am trying to find a carrier bearing assembly to fit.
Last edited by 87GN;
Sat Mar 23 2019 12:03 PM.
1955.1 3600 5 window 4 speed all original.
Re: carrier measure location
Yes that is the wrong spot, the machine finish on the next step down where the splines are cut should be 1.3780.
The part of the shaft that you are measuring is where the deflector goes.
Here is your part:
https:/ / www.classicparts.com/ 1954-98-Drive-Shaft-Support-Bearing-T1/ productinfo/ 92-905/
Last edited by sstock;
Sat Mar 23 2019 12:40 PM.
1953 Chevrolet 3100
261 cu inch, sm420, 3.55 rear, torque tube still,omaha orange, still 6 volt, RPO green glass, side carrier spare, all done
https://www.youtube.com/watch?v=Bli... n05i04t1aokgm4p04jiwgffwhyyih5xbk0h00410 1964 GMC 1000
305 Big Block V6, sm420, the next cab off restoration